Wall mounted, air and electricity powered, single-line pre-mix foam unit for doorways. Supports up to two nozzle assemblies with a total of 25ft total distance with a repeat cycle digital timer.
This is a direct replacement for the DS1.
24V Single-Line Pre-Mix Doorway Foam Unit - Datasheet
24V Single-Line Pre-Mix Doorway Foam Unit - Operation Manual
compressed air and electricity
draws from pre-mixed solution
one product
8 ft. (2.4 m) hose with 3/8 in. (9.5 mm) inside diameter
2 gal/min (7.6 l/min)
Santoprene, Viton, or Kalrez
repeat cycle
one nozzle: up to 9×4 ft. (2.7×1.2 m);
two nozzles: up to 5×3 ft. (1.5×0.9 m) at each nozzle
single-line nozzle assembly (NZA-DS-SL)
one control box can support up to two nozzle assemblies
the combined distance between the control box and the nozzle(s) must equal 25 ft. (7.6 m) or less
designed for use with 1/2 in. (12.7 mm) outside diameter tubing between control box and nozzle(s)
*dilution rates and flow rates given are based on chemical with viscosity of water and factory air pressure settings.
40-80 psi (2.8-5.5 bar) with 5-10 cfm (141.6-283.2 l/min)
40-100˚F (4.4-37.8˚C)
100-240 VAC, 50-60Hz, 1A (GFCI protected outlet)
24 VDC
Chemical products used with this equipment must be formulated for this type of application and compatible with unit materials and pump seals. For more information on chemical compatibility, consult the manufacturer or SDS for your product or contact our customer service department.
Choose a pump seal material that is compatible with the chemicals you will use. Chemical incompatibility can cause accelerated wear and equipment failure that is not covered by warranty, so it’s important to do your research.
We have distributors all over the world. Tell us a little bit about you and your equipment needs, and we’ll help you find or become a distributor.
